KORTING HK3203B Gebrauchsanweisung Seite 26

Consider the following advice and the instructions in the table before contacting the after-sales service in case a
problem arises
•
If the hob does not work, check that a black-out has not occurred.
•
If the hob has gone off during normal operation, check there are no objects on the Touch Control keys. If so, remove
the objects and tun on the hob again.
ERROR
CODE
F0
Touch Control software error.
The Touch Control part is too hot, all
Fc
cooking areas have been turned off.
Ft
The temperature control sensor of the
FE
TC may be damaged.
Extreme environmental light
FL conditions in the initial calibration
sequence.
FJ
FU
Software errors.
FA
FC
Fr
Relay self-control.
INITIAL TOUCH CONTROL CALIBRATION
1. Disconnect the hob from the electrical network.
2. Wait 15 seconds and connect it to the electrical network again.
3. Numbers will appear on the display for about 2 seconds.
4. Press ON/OFF when the numbers disappear (press without using gloves and with a clean finger).
Repairs must be carried out by the customer service qualified technicians.
The appliance may be exposed to significant risks, should it be repaired in an unprofessional manner.
CAUSE ACTION TO BE TAKEN
Run the procedure "INITIAL TOUCH CONTROL CALIBRATION".
If the error persists, contact the after-sales service.
Wait for the temperature to drop. The cooking phase is
automatically recovered when the correct temperature value
is reached.
Wait for the temperature to drop.
Should the message persist even when the temperature
reaches the environmental value, contact the after-sales
service.
Switch-off the lighting sources (e.g. the halogen lamps) as they
might create problems during the initial calibration phase.
Run the procedure "INITIAL TOUCH CONTROL CALIBRATION".
These errors are an automatic control of the software. The signal
disappears when the system goes back to a correct value.
If the error persists, contact the after-sales service.
Run the procedure "INITIAL TOUCH CONTROL CALIBRATION".
If the error persists, contact the after-sales service.
- 26 -