Troubleshooting - Geemarc loop hear LH100 Benutzerhandbuch

USING THE loopHEAR
The external microphone can also be wall mounted with the wall clip
supplied.
Downloaded from www.Manualslib.com
TM
Simply stick the wall clip to the wall
in the most convenient location.
Gently push the external
microphone into the microphone
holder.
11
manuals search engine

TROUBLESHOOTING

The RED LED is flashing
•
Charge the battery
TM
The loopHEAR keeps on switching off
•
Make sure that the batteries are fully charged
You cannot hear clearly due to interference or you cannot hear at all
• TM
.Make sure the loopHEAR
• TM
.Move the loopHEAR closer to you
BATTERY USAGE:
To ensure that your loopHear™ is always ready for use please follow the
recommendations below:
•
Always switch off when not in use
•
Always recharge the batteries after continuous use for more than 6
hours or when the red LED is ON
•
Recharge the batteries every four months if the unit has been
switched OFF for long periods of time
As a rough guide the battery will allow the following usage depending on
the volume levels and ambient noise:
•
STANDBY WHEN TURNED OFF
MONTHS
•
STANDBY WHEN TURNED ON BUT NOT IN USE
•
IN CONTINUOUS USE
HOURS FROM FULLY CHARGED BATTERY
is switched on and facing you
4
2 DAYS
8
12