Technical Specifications; Noise/Vibration Information; Operation - FAIRLINE 700000140 Originalbetriebsanleitung

e) Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades create
frequent kickback and loss of control.
Special safety advice relating to grinding
a) Always use the guard designed for the type of
abrasive consumable you are using. Always use
abrasive consumables
approved for use with your electrical power
tool. Abrasive consumables not approved for use
with your electrical power tool cannot be
adequately guarded and are unsafe.
b) To ensure the highest level of operational
safety, the disc guard cover must be attached to
the electrical power tool and set in such a way
that the smallest possible area of the abrasive
consumable is exposed to
the operator. The disc guard cover is there to
protect the operator from pieces breaking off and
accidental contact with the abrasive consumable.
c) Abrasive consumables must be used
only for their recommended purposes.
d) Always use an undamaged mounting
flange of the correct size and shape
for your selected grinding disc. Suitable
flanges support the grinding disc and reduce
the chance of it breaking.
e) Never use worn down abrasive consumables
intended for larger electrical power tools.
Abrasive consumables intended for larger
electrical power tools are not designed for the
faster rotational speeds of these smaller electrical
power tools and could break.

TECHNICAL SPECIFICATIONS

Voltage:
Power consumption:
Rated speed:
Drive spindle diameter:
Max disc diameter:
Sound pressure level L
230-240 V~/50 Hz
2000 W
6500 min
M14 mm
230 mm
: 94,5 dB(A), K=3dB(A)
pA
Sound power level L
Vibration level:

NOISE/VIBRATION INFORMATION

Measured sound values determined according to
EN 60745.
Wear hearing protection!
Vibration total values (triax vector sum)
determined according to EN 60745:
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in EN
60745 and may be used to compare one tool
with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents
the main applications of the tool. However if
the tool is used for different applications, with
different accessories or poorly maintained,
the vibration emission may differ. This may
significantly increase the exposure level over the
total working period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when it is
running but not actually doing the job. This may
significantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organization of work patterns.

OPERATION

-1
Before use
Before making assembly, changing and
adjustment for any accessory, disconnect the tool
: 105,5 dB(A), K=3dB(A)
WA
2
4,27 m/s , K=1,5 m/s
2
19