wehncke 13143 Gebrauchsanweisung Seite 14

The maximum filling pressure is 12 PSI (between 10 and 12 PSI is usually adequate).
GB
After inflation remove the inflation hose and replace the safety cap of the valve.
WARNING: If the product is exposed to the sun for an extended period, check the pressure from
time to time. If it exceeds 12 PSI, deflate slightly to avoid overstretching the material.
Deflation: Remove any water, sand and other debris from around the valve before removing the
safety cap.
Press in the valve pin slightly to release the air slowly from the board. When the air pressure has
decreased a little (usually after about 10 seconds), press the valve pin right down, twist it in a clock-
wise direction (Figure C) and affix it in this open position. When releasing the air take care that
sand and other debris cannot collect in or around the valve.
CAUTION: Always reattach the valve when the product is not being inflated or deflated. This avoi-
ds loss of pressure and prevents foreign objects from collecting in the valve cavity.
Important:
Do not over-inflate the board. Do not exceed the maximum inflation pressure of 12 PSI. Never use
a compressor. The guarantee does not cover damage caused to the board by over-inflation.
To ensure that there are no leaks, wait for about 24 hours after inflation before using the board.
If you notice a constant drop in pressure, refer to 'Repairs' below and look for the puncture.
Attaching the fins
Attach the fins when the board is fully inflated. The points of the fins should face towards the back
end of the board.
Screw on the fins as shown below.
14