Care & Cleaning; Troubleshooting - Sage BCP600 Kurzanleitung

Care & Cleaning
• Always ensure that the juicer is turned OFF at
the ON/OFF switch and the plug is removed from
the power outlet before cleaning, disassembling,
assembling and storing the appliance.
• Follow these instructions to clean all surfaces
or parts that come into contact with food
during juicing.
• For easy cleaning immediately after each use
rinse removable parts under warm water to
remove wet pulp. Allow parts to air dry before
reassembling.
• For thorough cleaning after disassembling the
appliance, all removable parts should be washed
in warm soapy water or on the top shelf of the
dishwasher. The base and juice press arm should
be wiped with a soft, damp cloth. All parts should
be dried thoroughly before reassembling.
• Store the cleaned and reassembled juicer in an
upright position in a cool, dry place. Do not place
any items on top of the juicer while stored.
NOTE
• Never immerse the motor base in water or any
other liquid. Do not use harsh abrasives.

Troubleshooting

POSSIBLE EASY SOLUTION
PROBLEM
Will not
• Switch not in the ON position
work
• Juice press arm not lowered
• Juicing cone or fruit dome
not assembled properly
• Filter not assembled properly
• Motor overload protection
may have operated
(see below)
Motor
• The juicer is fitted with an
Overload overload protector to prevent
Protection
damage to the Motor.
If the Motor suddenly stops
working after heavy or long
periods of use, turn OFF
at the ON/OFF button, unplug
from the wall and allow the
unit to cool for 15 minutes.
Once the unit is cooled you
will be able to use the juicer
again as normal.
NOTE: The unit MUST be
unplugged from the supply
to allow the protector to reset.
• Despite this overload
protector we suggest juicing
in smaller batches in order
to protect the Motor.
EN
7