Operation - Teesa TSA0520 Bedienungsanleitung

Owner's manual
Notes:
• Make sure the appliance is turned off before connecting it to the power supply.
• It takes about 8 hours to fully charge the device what provides about 45 minutes of
shaving time.
• It is recommended to charge the appliance once a week.
1. Connect one end of the power cable to the power supply socket, connect the other
end to the appliance's power socket.
2. When the appliance is charging, red LED is on.
3. When charging has finished, disconnect the power cable from power supply and the
device.
Shaving:
1. Slide Power switch upwards to turn on the appliance.
2. Move the shaving head against the direction of beard growth
using both circular and straight movements.
3. Gently press shaver to the skin, so the floating blades can easily
follow the contours of your face.
4. After shaving turn off the appliance by sliding Power switch downwards.
5. Clean the shaver according to the instructions included in "Cleaning" section.
6. Put the protective cap on the shaving head to protect the blades from any damage.
Trimming
1. Push the trimmer release slide downwards to open the trimmer.
2. Turn on the appliance.
3. Start trimming.
4. After trimming, turn off the appliance by sliding Power switch downwards.
5. Clean the trimmer according to the instructions included in "Cleaning" section.
6. Push the trimmer downwards until it locks in place to close it.
General:
• Do not immerse the appliance in water.
• Do not use any abrasives or chemical agents to clean this product.
• Clean only the casing with a soft and slightly damp cloth.
• Clean the appliance after each use. Regular cleaning guarantees better shaving
performance.
CHARGING

OPERATION

CLEANING
11
EN