Cinderella Comfort Bedienungsanleitung Seite 14

Fault finding / Messages
When lights are flashing, you should look
for the reason, and act before using the
toilet. Immediate action is required when
irregularities such as odours, poor incine-
ration or system failures occur, in order
to avoid consequential damage and unne-
cessary repair costs.
Error
Ash container
must be emptied
Ash container
must be emptied,
toilet locked.
No mains
power
Ventilation fan error
Hatch is jammed
/ bag is jammed
Ash container
in wrong
Heating circuit
interrupted heating circuit
Toilet lid opens.
Temperature
sensor is faulty,
shortcircuited or
broken.
During cleaning and fault finding, resetting the electronic unit may sometimes be helpful. Do this by pushing the start button, this
will cause a short beep to be heard. Hold down the button for about 8 seconds until a long beep is heard, then release button.
14
Error
message
Red Yel.
(Comfort)
Empty the
Flashing Flashing
ash container
Toilet locked Lamp Lamp
container full on
No power
Battery mode
Error fan
Flashing
Error hatch
Flashing
mechanism
Ash pan
Flashing Flashing
out of position
Error
Flashing
Lid is open
Flashing
Error
Flashing
temp.sensor
Status
messages Start button
Green Sound What to do
3
beeps
3
beeps
on
every 10. sec
3
Lamp
beeps
off
10
Flashing
beeps
10
beeps
3
beeps
Continuous
Continuous
Flashing
Error Combustion
Start button
Red light Yellow light
1 Remove and empty ash container.
Remove and empty ash container.
1
Connect mains power.
1
2
Open and close toilet lid.
Start incineration.
Check fan for obstructions.
1
2
Reset toilet by holding down 'start' button
for about 8 seconds until long beep is
3 heard. Open and close toilet lid. Start incine-
ration. If error persists, disconnect plug and
call for service.
1 When toilet is hot: Reset toilet. Push 'start'
button, but do not put a new bag in the
bowl. If unsuccessful, reset toilet, put new
bag in bowl, pour in 3 cups of water and
push 'start' button. If still unsuccessful, wait
until toilet has cooled (fan stopped). When
toilet is cool: Reset toilet, open lid and push
'start' button. Hatch opens and pieces of
paper may be removed manually.
1 Adjust position of ash container.
1
Disconnect mains plug.
2 Wait 15 minutes.
3 Check temperature sensor on right hand
side of toilet. Unscrew grey plug. Push on
fuse inside with finger, do not use any
sharp objects. A click is heard if fuse had
triggered. If so, check inlet/outlet air. If
fuse had not been triggered, call for service.
1 Close toilet lid.
1 Reset toilet by holding down 'start' button
for about 8 seconds until a long beep is
2
heard. Open and close lid. Start incineration.
If error persists, disconnect mains plug and
call for service.
Power
Green light