Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Level / GAIN
This regulator equalizes the sensitivity of the amplifier to match
the radio-output voltage. This regulator is not for volume adjust-
ment! Use clear music and increase the radio volume up to 75%.
Now turn the amplifier gain-regulator to the right until the sound
becomes unclear.
8. High / Low filter
Slide the switch for your configuration in the right position.
OFF: crossover off, unit gives back the entire frequency range.
L: Low-pass on, the unit plays only bass.
H: High-pass on, the unit plays only treble.
9. POWER-LED
The LED lights when the amplifier is switched on.
Checklist of main steps
1.Remove chassis ground cable from car battery.
2.Choose suitable place for the amplifier and mount is.
3.Install plust battery cable (with fuse) from battery to amplifier.
4.Short cable from the battery minus pol to the car chassis.
5.Install RCA cables with remote wire from radio to amplifier.
6.Amplifier GND to car chassis.
7.Connect alls cables to amplifier.
8.Reconnect minus (chassis ground) to battery.
9.Adjust as described.
10.Have fun!
12
Malfunction
Power LED doesn't
check all fuses on the amplifier
light up
check main fuse near the battery
check plus and minus battery cables
check remote voltage
Power LED is on but no
check volume control on the radio
sound
check GAIN regulator on the amplifier
check RCA cables and connections
check speaker cables an connection
Bass response is low
one speaker cable could be
misconnected
the bass regulator on the radio
is set on low
an active crossover unit is
adjusted wrongT
The amplifier switches
bad chassis ground connection to the
on and off
amplifier
cables terminal and battery terminals are
oxidated
low voltage from battery
remote wire is not connected right
If you can't solve any of these problems, please consult your dealer.
What to do
13
Werbung
