Werbung
Verfügbare Sprachen
Verfügbare Sprachen
over high-level (high in), to radio without a preamp outputs.
In this way is a direct connection to the speaker output of the
radio possible. The power supply is enabled by the ISO adapter.
Sharp edges must be protected to avoid damages to the cable
isolation (for example with a rubber cap). For safety and
relaibility the amplifier must be mounted on an suitable place for
example in the glove compartment, behind the radio or behind
the center console.
Please take care of:
• Adequate heat ventilation
• Safety from mechanical damage
• Dry
• Heat resistant surrounding
• Close to solid chassis ground contact
• Amplifier input-settings within easy reach
Please use high-quality connection parts.
We recommend a sound tuning without usind any sound
processors or equalizers.The radio volume should be set in the
middle.
1. Speaker connection
• Never connect the speaker cables with the chassis ground.
This could destroy your amplifier.
• Check that your speakers are connected corrextly wich means
plus to plus and minus to minus.
We recommend speaker cable from 0,75mm² to 1,5mm².
10
2. GND
Chassis ground terminal. The chassis ground cable must be
connected very tight on a nearby massive and electric
conductive place.
3. REM
Remote terminal. The remote cable must be connected with
the radio automatic antenna terminal so that the amplifier will
switch on and off automatically with the radio. In many cases,
the cable from the radio is blue / white, but definitely consider.
If there are 2 or more amplifiers connected to this antenna termi-
nal it might be necessary to add an additional relay.
Please consult your dealer.
4. BATT+
Battery + (plus) terminal. The + (plus) 12 Volt power cable
must be connected with a fuse on the battery + (plus) terminal
(without optional ISO cable). We recommend a 10 ampere fuse
an a copper cable with a thickness of 2,5mm² for cable length
up to 5 meters
.
5. High-In audio-input, front or rear
With the enclosed high-in adapter cable, it is possible to use the
speaker-output-signal from the radio, for older vehicles or radios
without RCA-output.
6. RCA audio-input, front or rear
These RCA inputs are to be connected with your radio preamp
RCA outputs. Please use RCA cables made for car audio, other-
wise there could be disturbances. Keep these cables as short as
possible. To avoid disturbances from your car electronic, install
the RCA cables not to close from existing car cables.
11
Werbung
