Installation - BOMANN DU 771 G Bedienungsanleitung, Garantie

Installation

Installation
Installation Installation
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 6 The distance must be The distance must be The distance must be
appliances, the distance must be at least 65 cm. appliances, the distance must be at least 65 cm. If appliances, the distance must be at least 65 cm. appliances, the distance must be at least 65 cm.
the installation instructions for the gas cooker specify
a greater distance, this distance must be taken into
consideration.
Selecting the fume outlet Selecting the fume outlet
Selecting the fume outlet Selecting the fume outlet
You can operate the cooker hood in two modes:
Extraction mode Extraction mode
Extraction mode Extraction mode
WARNING: WARNING: WARNING: WARNING:
• The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
• When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odours to the outside.
The extracted air is normally vented verti-
cally. The extracted air can vented
through the wall units and the loft floor to
the roof ridge.
If there is a conduit under the wall units,
the extraction duct can be routed so that
the extracted air can be vented horizon-
tally through the wall.
Recirculation mode Recirculation mode
Recirculation mode Recirculation mode
If you do not have a direct extraction vent to the out-
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, an activated carbon filter as described under
"Installing the activated carbon filter for recirculation
mode", must be used.
between 65 5 5 5 – – – – 75 cm. For between 6 between 6 75 cm. For gas 75 cm. For 75 cm. For
Activated carbon filter are not supplied. You can or-
der the carbon filter from your dealer or in our online
accessories shop,
the reference number found under "Technical Data".
gas gas gas
Assembly Assembly Assembly Assembly
WARNING: WARNING:
WARNING: WARNING:
• When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the mains.
• Failure to use the mounting fixtures may lead to a
risk of electric shock risk of electric shock risk of electric shock risk of electric shock.
CAUTION CAUTION: : : : CAUTION CAUTION
• Before mounting, check that the wall has sufficient
load capacity to bear the cooker hood.
• When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
• Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: : : : Recomm NOTE Recommendations for preparation work
NOTE NOTE Recomm Recomm
• When installing, ask another person to assist.
• Wear protective gloves to prevent injuries from
any sharp edges.
• Drill 8 holes in the wall to fix the casing.
• Insert wall plugs in the holes on the wall and in-
sert 2 screws ST4*40 to fix the casing.
• Fix the hood on the wall and use safe screws
ST4*30 to fix the casing.
• Fix screws ST4*40 on the wall.
• Fix the outside chimney.
15
www.bomann.de. To order, use www.bomann.de
www.bomann.de www.bomann.de
endations for preparation work
endations for preparation work endations for preparation work