Centrosolar S-Class Excellent Montageanleitung Seite 24

Installation guide
Mounting of grounding terminal on frame
The grounding terminal must be placed on the frame
in such a way that the screw touches the grounding
hole. Using a screwdriver, install the screw into the
grounding hole until its head is flush with the base
and the base is flush with the frame. Then, turn the
screw another quarter or half turn.
The thread-cutting screw should be torqued by
20.4 lb in and 24,8 lb in (2.3 and 2.8 Nm).
Wire placement
Insert the cable into the wire slot. Then push in the
wire on both ends into the slot. (The wire slot will
cause the wire to be slightly curved as shown.)
Termination
The slider must be engaged (slider covers the
base).
Using cable clamps, move the slider over the base
until it covers the base. This terminates the wire. To
open the slider a slotted screwdriver can be used.
24