Centrosolar S-Class Excellent Montageanleitung Seite 22

Installation guide
Warning: Danger due to high voltage!
Even in disconnected condition the inverter can re-
tain high voltages, which is a major shock hazard.
Therefore:
Be very cautious when working with the inverter
P 
and wires!
After switching off the inverter as well as before
P 
working on the inverter, make sure to regulate
the time intervals as recommended by the man-
ufacturer so that the high voltage components
can be discharged!
Make sure to adhere to the assembly regulations
of the inverter manufacturer!
Warning: Danger due to electric arc!
The solar modules generate a direct current when
exposed to light. When opening a closed circuit,
e.g. disconnecting the direct current wire from the
loaded inverter, a fatal electric arc may occur.
Never disconnect the solar generator from
P 
the inverter while the inverter is connected
to the grid!
Make sure to use only flawless wire connec-
P 
tions! Connect wires seamlessly and keep
them free from dirt!
Electrical Installation
The solar modules are designed for use in PV
systems of application class A and are approved
for operation in systems with dangerous direct cur-
rent (more than 120 V DC in accordance with EN
61730) and power. PV modules of this application
class are approved for operation in installations
with unrestricted access. Centrosolar AG modules
of this class, which are qualified under EN 61730
and have been properly installed, meet the re-
quirements of protection class II.
22
Transport, temporary storage
and safe unpacking
The modules are sensitive technical components,
which must be handled with utmost care. There-
fore, be particularly careful during transport and
temporary storage and leave the modules in the
package until they are used. Always lift and carry
the module with both hands and never carry by
means of the junction box.
Do not drop the modules or place them down
clumsily on a hard floor and/or on the module
corners. Do not place any objects on the mod-
ules. Do not stack the modules without protec-
tion.
Avoid deflection of the modules. Do not walk
on the modules. Do not treat with sharp ob-
jects and keep all electrical contact areas clean
and dry.
For documentation purposes, the serial number
should be noted. If required, the modules should
be temporarily stored in a dry, ventilated room.
Please pay special attention to the warnings
on the package as well as on the enclosed un-
packing instructions!