Inhaltsverzeichnis
Werbung
FCC Compliance Information
(FCC Part 15, Part 68, SAR test & measurements)
FCC Part 68 Information (valid for "DP 01" model only)
Note: The base unit of the "DP 01S" model ("Additional unit") should be
connected ONLY to the electrical mains, by using the power adaptor
provided in its original package.
The base unit of the "DP 01S" model ("Additional unit") acts only as a
battery charger for the DP 01 Handset units. For this reason, it should
NOT be connected to the PSTN (analogue telephone line) network!
1
The "DP 01" model complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the bottom of this equipment
is a label that contains, among other information, a product identifier
in the format US: A2TW401BDP01. If requested, this number must be
provided to the phone company.
2
The "DP 01" model uses the RJ-11 Universal Service Order Code (USOC)
jack.
3
A plug and jack used to connect this equipment to the premises wiring
and telephone network must comply with the applicable FCC Part 68
rules and requirements adopted by the ACTA. A compliant telephone
cord and modular plug is provided with this product ("DP 01" model
only). It is designed to be connected to a compatible modular jack that
is also compliant. See installation instructions for details.
4
On the "DP 01" model, the REN information is used to determine the
number of devices that may be connected to a phone line. Excessive
RENs on a phone line may result in devices not ringing in response to
an incoming call. In most but not all areas, the sum of RENs should
not exceed five (5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs, contact the
telephone provider. For products approved after July 23rd, 2001
(including this product), the REN value is part of the product identifier
that has the format US:AAAEQ##TXXXX. The digits represented by
## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For
earlier products, the REN is separately shown on the label.
5
If this equipment ("DP 01" model only) causes harm to the telephone
network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But if advance
notice isn't practical, the telephone company will notify the customer
as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
6
The telephone company may make changes in its facilities, equipment,
operations or procedures that could affect the operation of the
equipment. If this happens the telephone company will provide
advance notice in order for you to make necessary modifications to
maintain uninterrupted service.
29
Werbung
Inhaltsverzeichnis
