Functions; Function Description; Input; Reading In Data - Magnescale MG30-B1 Handbuch

3. Functions

3-1. Function Description

3-1-1. Input

Input signal
Reset
Start/Latch
Pause
Reference point load
Measuring mode select
Comparator set number select
Data request signal (DRQ)
Input request signal (LRQ)
Channel number selection signal
MG30-B1 / MG30-B2
Description
See MG10 Instruction Manual.
(One of the functions is
selected by the parameters in
the MG10 main module)
See MG10 Instruction Manual.
See MG10 Instruction Manual.
See MG10 Instruction Manual.
See MG10 Instruction Manual.
See MG10 Instruction Manual.
This is used when reading out
data.
This is used when loading
operation settings to the MG30.
This is used to designate the
counter module (channel) for
the operation or data output.

Reading in data

Only the channel number selection input and data request (DRQ)
input are used. (Timer mode is only for channel number selection
input.)
Set the channel number for operation beforehand, and then set the
DRQ to on and import the data.
For details, see "5. Timing Chart."
Operating the multi interface unit
After setting the channel number for operation and turning on the
contact point of the function to be used, set the input request (LRQ)
to on.
The reading-in operation is performed for the operation input and
the target channel number when the LRQ is turned on.
Input is invalid even if the channel number or operation input is
switched when LRQ is on.
3
(E)