Inflation; Deflating The Article; Attaching The Sunroof - Crivit Pool-Lounge-Insel Gebrauchsanweisung

Inflation

CAUTION!
• Always inflate all air chambers fully!
• Avoid overinflation, as there is a risk
of overstretching or even ripping the
welded seams.
• Use standard foot pumps or a double
stroke piston pump with the corre-
sponding pump adapters.
• Do not use a compressor or a com-
pressed air bottle to inflate the arti-
cle. This can lead to damage.
• Ensure that the chambers are inflated
with air evenly and in the right order.
• Inflate the air chambers until they feel
firm. If you press your thumb onto the
air chambers you should still be able
to depress them easily.
Note: You need a pump with a standard con-
nection for the screw valve (5) on the reclining
surface and for the valve (1b) on the back
section.
Inflate the air chambers in the following
order:
1. – Back section
2. – Reclining surface
Inflating the back section
1. Open the valve closure (figure C).
2. Press the valve shaft (1b) together and inflate
the back section until it feels firm.
If you press your thumb onto the back section
you should still be able to depress it easily.
3. Close the valve closure and depress the valve
using light pressure (figure C).
Inflating the reclining surface
1. Open the closure cap (5a) on the screw valve
(5) by turning it anti-clockwise (figure B).
2. Inflate the reclining surface with the corre-
sponding pump.
3. After the nominal pressure is achieved close
the screw valve (5) again by turning it clock-
wise.
Note: If you do not have a manometer then you
can use your thumb to test the correct pressure.
To do this, press the inflated reclining surface
with your thumb.
8 GB/IE/NI
The reclining surface is correctly inflated if it feels
firm and can still be pressed down easily with
your thumb.

Deflating the article

Back section
1. Pull the valve out.
2. Press the valve shaft (1b) together lightly so
that the air can escape. Or feed the deflation
tube (7) into the closure to allow the air to
escape quickly (figure I).
Reclining surface
Twist the screw valve (5) out of the threaded
opening (1a) on the reclining surface (1) in an
anti-clockwise direction (figure B).

Attaching the sunroof

Only attach the sunroof to the lounge island
when it is fully inflated. We recommend two
people attach the sunroof together. The rods
comprise several parts that are connected to one
another.
1. Insert the connected parts of the rods (3)(4)
into one another.
2. Insert the long rod (marked with red) (3)
through the front rod sleeve (2a) and the shorter
rods (marked with blue) (4) through the other
two rod sleeves (2a) (figure D).
Note: The front rod sleeve is located in the front
of the sunroof. The back window is located at
the rear.
3. Erect the sunroof over the lounge island (two
people should work together). Ensure that the
vision panel is behind the back section.
4. Insert the ends of the rods into the side plug
connections (1c) on the reclining surface (1)
(figure E).
Note: Please ensure that the ends are inserted
deep into the plug connection.
There are four attachment straps (2d) on the sun-
roof, each with one bar (2b) and one stopper
(2c).
5. Thread the bar (2b) through the hole on the
strap attachment (1d) and lay the bar cross-
wise (figure F).
6. Repeat the process with all four straps.