Installation; External Wiring - Rotheigner Air Premium 125 Bedienungsanleitung

1

Installation

GB
1. Mark the holes of the installation
brackets on the wall.
2. Drill the holes and fit the plugs.
3. Install the device with the screws.
2
Power supply
Shut down the automatic circuit
breaker. Make sure that is shut off
in all poles.
3
Electrical connection
An external switch e.g. light switch,
thermostat, etc. must be used to
control the device, it must be locat-
ed between the L and the
86
4A
External wiring / Seal
1. Cut off the cap from the seal.
2. Attach the seal to the appliance.
3. Install the strain relief clamp.
4B

External wiring

1. Slide in the cable through the seal
and the strain relief clamp.
2. Tighten the screws of the strain
relief clamp.
3. Connect it to the terminal as
shown.
4C
External wiring / Cover
If external wiring is used to connect
the device, cut out the cable port on
the cover.
wire.