HOW TO LIGHT THE PILOT
Pilot
High
Ignition
•
Check all connections prior to each use.
•
Turn on main gas supply at source.
•
Press to turn control knob anti-clockwise to „
•
Hold knob depressed, press Ignition button repeatedly until pilot flame is lit, then
continue to hold the knob depressed for 10 seconds until the pilot remains lit after
releasing knob.
•
If pilot fails to ignite, press to turn knob clockwise to "0" and repeat
HOW TO LIGHT THE PATIO HEATER
•
The pilot should be lit and the knob set to „
•
Hold knob depressed gently and turn anti-clockwise to „+".
•
When mesh glows lit, turn knob clockwise from „+" to „-" as required.
NOTE!
The burner may be noisy when initially turned on. To eliminate excessive noise from
the burner, turn the control knob to „
- 32 -
+
Control knob
" (see picture above).
".
". Then turn the knob to desired heat level.
OFF
-
Low