Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All operating elements and connections de -
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1 Receiving antennas
2 Button POWER to switch the receiver on / off
(keep button pressed for approx. 1 second)
3 Button SYNC to synchronize the receiver and
the transmitter: While keeping the synchroniza-
tion button pressed on the transmitter [SYNC
(D) starts flashing on the display], briefly press
the button SYNC on the receiver. Thus, the
transmitter is set to the transmission channel of
the receiver.
4 Display (
fig. 3)
A indication of operating mode
"MANUAL" manual frequency setting
(in steps of 25 kHz)
"SCAN"
channel scan
"PRESET" selection of a channel from one
of 4 preset groups (8 channels in
each group)
Use the button
mode (keep button pressed for approx. 1 sec-
ond).
B in the mode PRESET: indication of group
("P1" ... "P4")
C in the mode PRESET: indication of channel
number ("1" ... "8") within the group
D indication "SYNC" for synchronizing the re -
ceiver and the transmitter:
button SYNC (3)
E indication of channel number
F indication "MUTE"; to indicate muting of the
audio outputs when settings are made via the
buttons SET,
POWER (2) is pressed
G indication of radio frequency
H bargraph "RF" (radio frequency) for the
strength of the radio signal received
I bargraph "AF" (audio frequency) for the vol-
ume of the audio signal received
5 Buttons SET,
and
channel in the operating mode selected:
chapter 7
6 Volume control for the output signal of the
receiver
7 Antenna inputs A and B (BNC jacks)
or
to select the desired
and
(5) or when the button
to set the transmission
8 Audio outputs, each for connection to a micro-
phone input or a line input, e. g. of a mixer or an
amplifier
– XLR chassis plug, balanced
– 6.3 mm jack, unbalanced
9 Level selector switch for the audio outputs (8),
to match the output level to the input of the
audio unit connected
MIC for connection to a microphone input
LINE for connection to a line input
10 Control to adjust the squelch threshold
11 Power supply jack to connect the power supply
unit provided
2 Safety Notes
The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING
The power supply unit uses danger-
ous mains voltage. Leave servicing
to skilled personnel only. Inexpert
handling may result in electric shock.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range: 0 – 40 °C).
G
Do not operate the receiver and immediately dis-
connect the power supply unit from the mains
socket
1. if the receiver or the power supply unit is visi-
bly damaged,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled
personnel.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
are not correctly connected or operated, or if
they are not repaired in an expert way.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
.
GB
9
Werbung
Inhaltsverzeichnis
