ProfiTech Pro 300 Bedienungsanleitung Seite 25

3. Loosen the countersunk screw in the middle of the brew group and the shower plate with an Allen
wrench (3 mm).
4. The shower screen and the shower holder (brass) can be removed easily.
5. Under the shower holder is a thin ring, the gasket of the shower plate.
6. The group gasket can only be removed by inserting a thin screwdriver between shower holder and
group gasket. Pry out the group gasket (the old group gasket will be damaged / destroyed).
7. Before installing the new group gasket clean the groove completely. When inserting the group gasket,
make sure that the bevelled side is facing upwards so that it is no longer visible.
8. Gradually press the group gasket into the pre-cleaned groove.
9. Then screw in the shower plate and the shower holder.
10. In order to ensure that the group gasket is inserted properly, carefully clamp a filter holder without filter
into the brew group.
Follow the steps as indicated below:
1.
Brew group at the beginning
4.
Remove the thin gasket of the
shower tray
7.
Clean the groove before inserting
the new group gasket
Bedienungsanleitung PRO300 / Instruction manual PRO300
2.
Remove the countersunk screw in
the middle of the brewing unit
5.
Now the group gasket can be
removed.
8.
Insert the new group gasket with
the rounded side facing upwards
24
3.
Remove the shower screen and
the shower plate
6.
Remove the group gasket with a
screwdriver
9.
Re-insert the gasket and the
shower screen as seen in pict.4
and tighten them with the
countersunk screw.