Auto Control Or Top Zone; Leds And Pushbutton Actions Fonctionning - Jri Mini Spy Rf Bedienungsanleitung

Auto control or top zone

The type of action depends on the Mini SPY RF configuration.
TOP ZONE = Transport mode and AUTO CONTROL = Storage mode. This function enables you to customise an action of measurement check-
up. You just have to press shortly on the pushbutton.
The action is recorded and will appear on the curve when you process the data with your software Sirius.
Leds and pushbutton actions functioning
The green led is on 2'' when the measurement starts and then flashes each 1' in recording mode.
Specials functionning regarding the recorder using mode
Device set up in storage mode
Mode
OFF
Waiting setup
Starting measurements
Pushbutton
Delayed (date & time)
Immediately
Mesure
Device set up in transportation mode
Mode
Off
Waiting setup
Starting measurements
Pushbutton
Delayed (date & time)
Immediately
Mesure
©JRI Maxant
T° OK (green led) flashes
during 10''.
Alarm led (red) flashes
during 10''.
Pushbutton pressing
Green led 2" = beginning of measurements
Green led 10" = auto control
Pushbutton pressing
Green led 2" = beginning of
Green led 10" = Top zone
< 5"
-
Red led 2"
-
-
< 5"
The 2 leds are on and flash at the same
-
Red led 2"
measurements
The 2 leds are on and flash at the same
time = Waiting for starting measurements
The 2 LEDs are on and then flash
-
alternatively = ending measurements
The 2 LEDs are on and then flash
alternatively = ending measurements
5''> pressing <10''
The 2 leds are on and flash at the
same time.
-
-
-
-
-
5"<appui>10"
time.
-
-
12