Start; Configuration; Measurement Start; Automatic Start - Jri Mini Spy Rf Bedienungsanleitung

Start

-
-

Configuration

Mini SPY RF configuration is done from the Sirius software and then transferred into your Mini SPY RF by radio frequency.

Measurement start

The Mini SPY RF has 2 starting mode:

automatic start

manual start

Automatic start
Your Mini SPY RF starts recording:
automatically when the configuration is transferred,
at a programmed date and time:
Manual start
Press shortly on the pushbutton

Alarm visualisation

The Mini SPY RF is equipped with different alarm indicators, when a threshold limit is overpassed.
Alarm LED (red):
Flashes every 15''.

Measurement stop

Depending on the configuration, the Mini SPY RF can stop recording or not. The different options are:
Rolling memory: once the memory is full, the new values replace the oldest.
Full memory: the recorder stops when the memory is full.
From the software: you can put the Mini SPY RF in standby mode with Sirius when you do not use your recorder.
From the pushbutton: this option is valid only if the Mini SPY RF is configured in transport mode with a start by pushbutton.
©JRI Maxant
To start your Mini SPY RF, please press between 5 and 10" on the button:
- the 2 LEDs are on and flash at the same time
all display segments are also on
- Mini SPY RF is now in waiting mode
Remark: If you press >10'' => no effect => remains off
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
dd / mm / yy
hh / mm / ss
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
To stop your SPY RF, press between 5 and 10" on the button:
- The 2 LEDs are on and then flash alternatively.
11