Maintenance And Cleaning - IKA KS 3000 i control Betriebsanleitung

Maintenance and cleaning

The shaker KS 3000 i control and KS 3000 ic control is mainten
ace free. It is subject only to the natural wear and tear of compo-
nents and their statistical failure rate.
Examine in regular intervals the functionality and the correct
attachment of the two gas-filled supports!
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been cleaned
and is free from any materials which may constitute a health
hazard. Use only cleansing agents which have been approved by
IKA to clean IKA devices
To remove use:
Dyes isopropyl alcohol
Construction materials water containing tenside / isopropyl alcohol
Cosmetics water containing tenside / isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
For materials which are not listed, please request information
from IKA. Wear the proper protective gloves during cleaning of
the devices.
Electrical devices may not be placed in the cleansing agent for the
purpose of cleaning.
Before using another than the recommended method for cleaning
or decontamination, the user must ascertain with the manufactu-
rer that this method does not destroy the instrument.
Collecting tray with drain hose (for picture see below)
(applies to KS 3000 i control and KS 3000 ic control)
In the event of glass breakage, leaking liquid is collected by the
collecting tray below the shaking table and guided to the drain
hose via a drain at the rear.
1. Remove drain hose from bracket
Cleaning of the collec-
ting tray:
- loosen four countersunk
head screw at the top side
of the shaking table
- remove shaking table
upward
Cleaning the Plexiglas cover:
- Do not dry wipe!
- Do not use abrasive materials!
- Do not use solvents!
Clean dusty surfaces with warm water, detergent and a soft cloth.
We recommend the anti-static plastic cleaner "AKU" by Burnus
GmbH, Darmstadt.
For disinfecting, only use products prescribed by the manufactu-
rer specially for use on Plexiglas
Ordering spare parts
When ordering spare parts, please give:
- Device type
- Manufacturing number, see type plate
- Software version
- Item number and designation of the spare part,
see www.ika.com.
2 Place drain hose in laboratory
drain
Repair
The device must be clean and free from any materials which may
constitude a health hazard when sent for repair.
Use the „safety declaration" included or download the form
from the IKA® website www.ika.com.
Please return the appliance in its original packaging. Storage
packaging is not sufficient for returns. Please also use suitable
packaging for transportation.
 
 
22