Tig-Welding With Lift-Arc (Without Hf) - OTC DAIHEN EUROPE DTX 2500 Handbuch

TIG-welding
5. Connect an air-cooled torch
 Please screw the torch to the connection A of the device.
 Fix the ground terminal to the connection D at the front panel.
 Please fix the gas hose of the torch to the pressure regulator.

6. TIG-welding with lift-arc (without HF)

Preparations for the TIG-welding
 Please fix an appropriate electrode and gas hose to the welding torch.
 Screw the ground cable at the connection A.
 Please connect the main cable D with the electric circuit.
 Set the main switch of the device on the position 1.
 Please set the position for the TIG welding with the button MODE
 Please choose now all the desired welding parameters.
 Open the valve of the gas cylinder.
DTX 2500
3 x 400V / 50-60 Hz
GB