Sissel Warming underbed Gebrauchsanweisung Seite 5

Switching on:
Don't switch on the SISSEL
following these steps:
1. There are two densities of points on the SISSEL
warming underbed.
concentrated points is especially for the feet. Do not
reverse!
2. Do not cover the area on the bed intended for head
and pillow with the SISSEL
3. Make sure to place the SISSEL
on the mattress correctly: the connection box
should at the upper side of the mattress which is
near the user's shoulder; and the user's feet should
be in the additional warming zone for the feet (with
more concentrated points).
4. Insert the controller plug into the detachable
connector on the SISSEL
5. Spread the SISSEL® warming underbed out flat on
the mattress and remove any folds or wrinkles.
Each time when the SISSEL
used, please check that it is spread absolutely flat
on the mattress. Then cover the SISSEL
comfort add a thin blanket or duvet between the SISSEL
sheet.
6. Plug in the flat plug of the SISSEL
make sure the switch should not be covered or placed on top of the SISSEL
underbed when it is in operation.
®
The SISSEL warming underbed has additional heat for foot zone.
The appliance may only be used with 230 Volts a.c.
Switch on the SISSEL
When switch on it will have 3 times beep – beep – beep sounds to ensure the user has
operated the switch correctly.
The warming underbed warm-up time is approx. 15 minutes.
Setting 0 = appliance off, the warming underbed
is disconnected from the power
supply.
Setting 1 = minimum warmth (setting 1 is
recommended for continuous use.)
3 colors LED:
 Yellow/Green light: indicates warming up
 Red light is a warning light: disconnect the SISSEL
immediately!
AG 02 V2
®
warming underbed until you make sure it is well-installed by
The part
®
warming underbed.
®
warming underbed
® warming underbed.
® warming underbed is
®
warming underbed into the socket for operating and
® warming underbed using the hand-operated switch.
®
with more
®
warming underbed with a bed sheet. For longer
Setting 2-3 = moderate warmth
Setting 4 = maximum warmth
warming underbed from power
®
®
warming underbed and bed
®
warming
4/20