Changing The Carbon Brushes; Cleaning; Disposal - Zipper ZI-ABH1050 Originalbetriebsanleitung

15.2

Changing the carbon brushes

If the carbon brushes are worn down to the wear limit may result in engine damage. Both
carbon brushes should be replaced together. The procedure is ident in both models.
 Loosen the screws of the cover M4X12.
 Take off the cover and unscrew the brush cap.
 Remove the carbon
 After replacing the carbon brushes rotate the brush cap back on.
 Screw the cover back on.
15.3

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.4

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
ABBRUCHHAMMER / DEMULITION BREAKER
brushes.
ZI-ABH1050/1500
N O T I C E
MAINTENANCE
Seite 37