Safety Caution - CombiSteel 7013.0130 Gebrauchsanweisung

5.4 The speed adjusting
Set the speed button to "O" position (Drawing 3-1), connect the electronic power, indicator light will be on. Start
the machine by turning the button in a clockwise direction to adjust the speed according to property of mixing
thing and the mixing agitator. The speed will increase while the button from left to right.
When the arrow is standing on top (drawing 3-2), the mixer is low speed, this is good for dough.
When the arrow is standing in the middle has (drawing 3-3), the mixer is at middle speed, this is good for meat
dumpling stuffing.
When the arrow is standing right (drawing 3-4), the mixer is at high speed, this is good for eggs.
This mixer has variable speeding, so you can choose best speed for your job.
Rotary direction: (from shaft out): The rotary direction of main shaft cover (item 44) is clockwise (red arrow) and
rotary direction of mix shaft (item 11) is anti-clockwise.
Note: Don't go against the rotation direction as written above. Otherwise the working efficiency will be reduced.
Or the mixer will break. Don't use the machine over 10 minutes each time. The max. flour weight to mix doesn't
be over 500 gr.
5.5 How to adjust the height of the mixing agitator.
Sometimes the interval between bottom of mixing agitator to bowl is too close and sometimes it is too big,
adjusting the height of mixing agitator is necessary. Detail is bellowing (drawing 4).
a. Shut off the power.
b. Use a wrench to release the nut of the mixing agitator.
c. Adjust the interval.
d. Tighten up the nut.
5.6 When the job is finished, please return the speed button back to "O" position, then turn off the machine,
shut off the power.

6 Safety caution

6.1 Remove the machine, after shutting of the power. When disassemble the mixing agitator, the mixing bowl
machine must be turn off.
6.2 Don't use wet fingers on operating the machine.
6.3 Don't wet the unit or immerse the mixer in water.
6.4 If any parts are broken or it does not work the way it shoot be, stop the machine, waiting to fix it by
technician.
6.5 Don't put any fingers in the bowl while it is working.
6.6 Under age persons please keep away from the machine.
6.7 When the machine is working or the head is raising, the handle "e" must be at vertical position.
6.8 When the head is raising, don't put any fingers or link parts between head and stand of machine for injury.
6.9 There is a ground point (Mark .......) at the back please keep this in original position after each maintenance.
8
www.combisteel.com