Preparing For Use - GEMM-SRL DELICE ARP 20 Bedienungsanleitung

7.4 – CONTROLS
As a whole the appliance is controlled by a rear panel digital thermostat.
As soon as the appliance is connected to the electricity supply, the display lights up completely for a lamp test lasting a
few seconds. At the end of the lamp test, the display goes automatically to how it was before the appliance was switched
off, for example if a cycle was in progress at that time, the cycle will restart from the point it was interrupted.
With the PCB OFF, the display is not lit except for the icon . Upon pressing key the icon goes out and the
display comes ON showing the temperature in the cabinet.
Use the commands on the thermostat, helped by the indications on the display, to activate the various appliance
functions.
If the buzzer sounds for any reason whatsoever, it may be muted by simply pressing any key.
Whatever the status of the appliance, after having activated the keypad, pressing the key puts the PCB to OFF.
7.5 – PREPARING FOR USE
Before using the appliance, the inside of the cabinet should be thoroughly cleaned.
When switching on after installation or if the appliance has not been used for a long time, it is a good rule to let it operate
empty until the set temperature has been reached.
To get the best performance from the refrigerated cabinet, arrange the stored products so that air can circulate properly:
do not obstruct the refrigerating unit intake, do not lay products and mixtures on top of each other and distribute the load
evenly.
Do not load the appliance with more than the allowed quantities, do not put in products and/or mixtures having a
temperature above the indicated design room temperature and avoid pointlessly opening the door otherwise the
efficiency of the refrigerating unit will be reduced.
ARP_ARG Rev03 05-2013
pag. 55