Restore Factory Settings - HomeMatic HmIP-BSM 2 Installations- Und Bedienungsanleitung

Restore factory settings

Short orange
flashing
(every 10 s)
1x long red
lighting
6x long red
flashing
1x orange and
1 x green
lighting
8 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the switch actuator and
meter, please proceed as follows:
• Remove the rocker (if necessary).
40
Teach-in
mode active
Transmission
failed or duty
cycle limit is
reached
Device
defective
Test display
Please enter the last 4
numbers of the device
serial number to confirm
(see "6.3 Teaching-in" on
page 36).
Please try again (see
"7.1 Command not
confirmed" on page
38 or "7.2 Duty cy-
cle" on page 38).
Please see your app
for error message or
contact your retailer.
Once the test display
has stopped, you can
continue.