Standard Setup And Cable Connections - Hughes & Kettner era2-series Handbuch

-
32 Auto Sleep
Commission Regulation (EC) no. 1275/2008 requires electronic devices
to be equipped with a power-saving function that switches off the device
after a specified period of non-use. That's what the era 1
does. Auto Sleep can be activated and deactivated using a thin, pointed
object to press the recessed button next to the speaker jack.
on
off
Button up (not pressed) = deactivated
Button down (pressed) = activated
The era 1 era 1 / era 2 era 2 ships with Auto Sleep activated, so the amp will shut down
if it's left to idle continuously for around 90 minutes. If Auto Sleep shuts
the amp down, you can wake it up by flipping the Power switch off and back
on again.

2 Standard Setup and Cable Connections

Level
REC
Audio Interface
era 1 / era 2 era 2's Auto Sleep
PLAY
CH 3
Lift EQ
-
33 Power
Set this switch to On to get the mains power flowing and to Off to cut it
off again.
-
34
Mains
Connect the factory-included power cord (Mains Lead) to this socket.
Before you power the amp up, make sure the voltage rating indicated on
the device matches your local mains current.
-
35 Factory Reset
To trigger a factory reset, use a thin, pointed object such as a paper clip to
press and hold for five seconds the recessed button in the round hole next
to Auto Sleep. The LEDs on the control panel will flash twice to confirm that
the amp's factory settings have been restored.
Tuner
FX
CH 4
Level
FS-2
era 1 / era 2 – Manual 1.2
CH 2
Power Power
CH 1
7