Tiger SW1202H Benutzerhandbuch Seite 44

Wearing your TIGER smartWATCH
Proceed as follows to use the heart rate monitor on your TIGER smartWATCH:
• Put the watch on so that the optical sensor on the back of the watch rests
snugly on your skin. The closer the contact between skin and watch, the better.
• Wear the watch above your wrist and not on your wrist. Particularly if you have
a slim wrist, wear the watch higher up your forearm if the watch is being used
to measure your heart rate.
Monitoring the heart rate
• The values for the heart rate may possibly be inaccurate depending on the
measuring conditions and environment.
• Measure your heart rate while you are sitting down and relaxed.
• If the heart rate is measured at low temperature, the result may possibly be
inaccurate.
• Move as little as possible while the heart rate is being measured. Otherwise the
results from measuring the heart rate may be inaccurate.
• In the case of users with slim wrists, the measurements of heart rate may
possibly also be inaccurate.
• Inaccurate measurements will occur if the device is worn loose on the wrist and
the light that is used for the measurement is reflected inconsistently.
• If the result differs greatly from the expected heart rate, rest for 30 minutes and
then measure your heart rate again.
• The results are calculated using average values and should therefore be repeated
at least five times.
44