Cleaning And Storage; Troubleshooting - THERMOMAXX JNSB-120Y2S Gebrauchsanleitung Und Sicherheitshinweise

4. Using the corresponding keys, you can additionally activate the top and bottom heating
element, each with 400 W.
5. Set the TURN switch to I and the heater will automatically oscillate from left to right in
order to evenly distribute the heat.
6. To turn the device off, set the respective switch to 0. To completely turn off the device,
set the POWER switch to 0. After use, disconnect the mains plug.
PLEASE NOTE: It is only possible to activate the top and bottom heating element and the
oscillation function once the POWER switch has been set to I.

Cleaning and Storage

PLEASE NOTE!
❐ Before cleaning, always disconnect the mains plug and let the device cool off.
❐ Never immerse the device, the mains cord or the plug in water.
❐ Do not use any corrosive or abrasive cleaning agents to clean the appliance. They could
damage the unit.
• If necessary, dust off the device or clean it with a damp cloth. Then wipe it off completely
with a dry cloth.
• Store the device in a dry place that is protected against dust.

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct the
problem yourself. Otherwise, contact our Customer Service department.
Do not try to repair a faulty device yourself!
Problem
When using the device for the
fi rst time, it is emitting an un-
known odour.
The unit is not functioning.
Possible cause/solution
There is still production residue in/on the device.
This is normal and no longer occurs later on. In this case,
ensure that the room is well ventilated e. g. by opening
windows all the way!
• Is the POWER switch set to I?
• Has the power plug been correctly inserted in the
socket?
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
• The safety switch has been thrown. Check whether
the device is in a level position on a level surface.
17