Operating Mode; Automatic Mode - DELTACALOR PLATE ELECTRIC PLUS 750 W Installation Und Anwendung Handbuch

Saturday and Sunday
Note - You can customise your program. See
the next part "Working mode definition" chapter
"Program" for more explanation.
Current stage
of the program
Currrent time
At any time, when the backlight is extinct,
press the OK key to lit-up the backlight.

Operating mode

The thermostat offers multiple functions de-
pending on the type of system (unit installed).
The available functions and settings differ ac-
cording to the model of the receiver / receiv-
ers connected to the thermostat (eg room
temperature control, floor temperature
(floor radiant panel system), room tempera-
ture with floor probe for limitation tempera-
ture, operation with pilot wire, etc.).
Autonomous operation
(available for all models of receivers)
The thermostat offers different operating
modes that allow the user to configure the
system according to his needs.
To change the working mode:
• Open the small center cover to have access
to the navigation keys [<] or [>].
Hold down one of the two keys to bring up
the menu bar of the operating modes.Move
the frame cursor on the desired working
mode and press OK to enter in the operat-
ing mode you have chosen. On the thermo-
stat the main screen will be displayed again
with the manual operating modes or you will
be asked to make the relevant settings (pro-
grams, holiday, etc.).
Manual mode Confort
Manual working mode, the comfort setting
temperature will be followed all the time.
By pressing [-] or [+] keys, the comfort set-
Program
ting temperature starts to blink and can be
followed
adjusted.
Manual mode ECO
Manual working mode, the reduced setting
temperature will be followed all the time.
In cooling mode, Reduced mode acts like the
OFF mode (system is stopped).
By pressing [-] or [+] keys, the reduced set-
ting temperature starts to blink and can be
adjusted.
OFF mode
Use this mode if you need to switch off your
installation.
Be Careful - In this mode your installation can
freeze.
At any time, when display is off, press on the
OK key to display a few seconds the current
temperature and time.
To restart your installation, use the navigation
keys [<] and [>].

Automatic mode

This mode is normally used for better com-
fort and energy savings. Depending on the
current time, the thermostat will keep the
temperature set in the selected program
(preset programs: P1 to P9) or in the program
created (user programs: U1 to U4).
You can easily override temporarily the cur-
rent program by pressing [-] or [+].The
thermostat jumps to Timer mode in which
you select a setpoint and a time. The thermo-
stat returns automatically to the Automatic
mode at the end of the time.
[ EN - 32 ]