Time And Date Adjustment - DELTACALOR PLATE ELECTRIC PLUS 750 W Installation Und Anwendung Handbuch

Close the two side's covers.
Now your thermostat will propose you to
adjust the current time and date.

Time and Date adjustment

Each time a value blinks, you can adjust it with
the [-] and [+] keys, once the value is chosen,
validate it with the OK key. The thermostat
will jump automatically to the next value.
Remark - You can always pressing the escape
key ESC.
List order of the time and date
adjustments
Time and day:
• Adjustment of the hours,
• Adjustment of the minutes
• Adjustment of the day (1 = Monday)
Date:
• Adjustment of the day number
• Adjustment of the month number (01 to
12)
• Adjustment of the year
Then the message "Save" and blinking green
LED appears, press OK to validate the ad-
justed time and date. You can always reach
the time and date adjustments, by pressing
and maintaining the edition [O] key during 2
seconds in normal operating modes.
RF installation
With receivers
First of all to configure your thermostat with
the receiver, you must put your receiver in «
RF init » mode (refer to the receiver leaflet,
only the RF receiver of the same range are
compatibles).
Now on the thermostat press and maintain
the edition key [O] during 5s, then the pa-
rameter « RF ini » must be display.
The thermostat will send now the radio con-
figuration signal to the receiver.
After few seconds the thermostat and receiv-
er should exit by their self the RF init mode,
this is the normal procedure to confirm a
correct pairing.
Now you can check the RF distance, go to
the room which must be regulated. Put your
thermostat on the final position (On the
wall or table...), then put the thermostat in
Comfort mode (setting temperature position
37°C). Close the door and go to the receiver
to check if the new status of the thermostat
has received.
Now return to the thermostat and switch
off it. Check on the receiver again if it's also
switched off.
If the RF signals were received correctly, ad-
just your setting temperature as you want.
If the RF signals weren't received correctly,
check the installation (Receiver position, dis-
tance...) or restart the RF init rules to be sure.
To make the installation easier, it will
be better to have the thermostat near
to the receiver during the configuration
mode. (A minimal distance of 1 meter
must be respected)
Case of Central
Link is done with central.
Starting
By default, mode automatic
standard built-in program "P1". "P1" program
details:
Monday to Friday
[ EN - 31 ]
follows the