Channel; Ockout; Revert Channel - Kenwood TK-3160 Bedienungsanleitung

T C
EMPORARY
During Scan, if a key is programmed with the Scan Temporary
Delete function, you can temporarily remove specific channels
from the scanning sequence. When Scan stops at a channel,
you can remove that channel from the scanning sequence by
pressing the Scan Temporary Delete key.
• To add the channel back into the Scan list, simply exit Scan mode
or switch the transceiver OFF and then ON again.
R C
EVERT HANNEL
During Scan, pressing the PTT switch to transmit will cause
the transceiver to select the revert channel. Your dealer can
program the revert channel using one of the following
methods:
• Last Called: The last channel received is assigned as the
new revert channel.
• Last Used: The last channel responded to is assigned as
the new revert channel.
• Selected: The last channel selected is assigned as the
new revert channel.
• Selected + Talkback: If the channel has been changed
during Scan, the newly selected channel is assigned as
the new revert channel. However, the transceiver also
transmits on the channel where Scan is currently paused.
• Priority: If your dealer has programmed a Priority
channel, it is the revert channel.
• Priority + Talkback: If your dealer has programmed a
Priority channel, it is the revert channel. However, the
transceiver also transmits on the channel where Scan is
currently paused.
18
L
HANNEL

OCKOUT