Heinner VDE001 Anleitung Seite 5

Guaranteed sound power level: 105 dB(A)
Tool description
1 Sprocket cover
2 Tension adjustment knob
3 Tension adjustment knob ring
4 Saw chain
5 Guide bar
6 Spike bar
7 Front handle
8 Hand guard (release for chain brake)
9 Oil tank cap
10 Trigger Start
11 Rear handle
12 Cord retainer
13 Oil Tank Inspection
14 Switch lock button
Before starting the equipment
Chain saw installation and chain tensioning.
Always pull out the power supply plug and
wear protective gloves before doing any
work on the chain saw!
1) Unscrew the tension adjustment knob and
remove the guide bar cover;
2) Set the saw chain over the guide bar, with the
teeth pointing to the tip of sword;
3) Place the guide bar with chain on the guide bolt
15 Sproket
4) Set the guide bar cover back in place, tighten it
by turning the knob to the left, then tensioning the
saw chain by turning the knob ring to the left. At
last tighten the knob firmly.
CHAIN BRAKE TEST
Before cutting with your saw, the chain brake
should be tested as follows:
A. Make sure the chain brake is disengaged (hand
guard is pushed back);
B. Place the saw on a firm, flat, dry surface that is
clear of any debris;
C. Plug the unit into the power source;
D. Grasp the front handle with your left hand;
E. Grasp the rear handle with your right hand;
F. Depress the LOCK/OFF button with your right
thumb. Squeeze the trigger with your index finger;
G. Activate the chain brake by rolling your left
hand forward against the lever;
H. Chain and motor should stop abruptly.
Operation
Before plugging in, check the plug and cable for
damage. If case, have it repaired by a specialist
immediately. The power cable must always be
behind the operator. When starting the saw, the
chain must not rest on the processed material.
Switching on/Switch off
Hold the chain saw with both hands when starting
up and during operation.
Switch on - Press the switch lock button, and then
power switch. In case the chain saw does not start,
release the brake lever.
Switch off - release pressure on the switch.
Operating the Chain Saw
Before starting to cut, pull the brake back towards
the front handle. In case the cut cannot be
completed in one run, slide the saw out, position
the bumper spike and cut by lifting rear handle.
When performing several cuts, the chain saw must
be switched off in between.
Switch off the chain saw engine before releasing
the chain brake. Do not let the chain saw touch the
ground when it is running.
The saw heats considerable during
operation. Be careful not to touch hot
parts with your body. Always stand to the side of
predicted fall line of the tree that is to be cut.
CHAIN BRAKE/ HAND GUARD
ELECTRIC CHAINSAW
5