PureLink CSW100 Benutzerhandbuch Seite 3

3. CONNECTION
Step 1:
Use an HDMI cable to connect the HDMI IN of the CSW100 transmitter with a source device. You can
use another HDMI cable to connect the HDMI OUT to a display (Loop-Through).
Step 2:
Use an HDMI cable to connect the HDMI OUT of CSW100 receiver to a display device.
Step 3:
(Skip this step if you don't need IR Extension) Connect the IR emitter to the CSW100 transmitter. Then
place the emitter in front of the source device's IR receiver. Connect the IR receiver to the CSW100
receiver. Then place the receiver probe in place, accessible for your remote control.
Step 4:
Connect a DC 5V1A power adapter to the power jack (MicroUSB) of the CSW100 transmitter.
Step 5:
Connect the other DC 5V1A power adapter to the power jack (MicroUSB) of the CSW100 receiver.
Step 6:
To pair receiver and transmitter, press the MODE key on the receiver's box and then press the MODE
key on the transmitter.
ENGLISH
-03-