T+A DAC 8 Betriebsanleitung Seite 28

Headphones   
   
   
(Headphones)
   
Display elements / Remote control receiver

 
Remote control
receiver
Display
Socket for stereo headphones with a minimum impedance of
32 Ω.
When headphones are plugged in, the analogue outputs are
   
automatically switched off.
Note regarding the use of headphones
     
 
Continuous listening to programme material at very high
volume using headphones or earphones can result in
permanent loss of hearing. You can avoid subsequent health
problems by avoiding continuous listening at high volume
through headphones or earphones.
(behind the Perspex screen)
When using the remote control system please point the F8
     
 
handset in the direction of the receiver.
The line of sight between the F8 and the remote control receiver
in the DAC 8 must not be interrupted by any obstacles. Installing
the DAC 8 behind the glass doors of a cabinet will also adversely
affect the remote control system.
It is essential to prevent potentially interfering light (from
fluorescent lamps and energy-saving bulbs) falling directly on the
receiver, as this may markedly reduce the effective range of the
remote control system.
The front panel of the DAC 8 incorporates a screen which
provides information about the amplifier's operational state.
Additional information can also be called up on the screen when
desired.
Screen segments:
 Four-digit alpha-numeric display area. The sampling

 
•
frequency is constantly displayed here. If you alter any value
- e.g. if you change the volume setting, or select a new
source - then the new value is briefly super-imposed here.
The meaning of the individual illuminated symbols is listed in
the table on the next page.
Segment 
•
which display supplementary information relating to the
current mode of operation.
 The remote control receiver is located here.
  
•
 of the screen contains eight illuminated symbols
 
28