Safety Information - OK International PS-800 Benutzerhandbuch

SERVICE AFTER WARRANTY
OK International will repair or replace (at OK International's sole option) a PS-800 Power Supply
that fails in normal use within one year (1) year after the expiration of the one-year warranty at the
then current repair or exchange rate. To return a failed Power Supply for repair or replacement,
follow the steps outlined below. This offer does not apply to any previously opened, modified,
repaired, altered, misused or damaged Power Supply.
REPLACEABLE COIL ASSEMBLY WARRANTY
OK International warrants the coil assembly against material and workmanship defects for a period
of 30 days.
REPLACEABLE HEATER -TIP WARRANTY
OK International warrants that the heater-tip will operate according to specifications for the lifetime
of the tip plating. A heater tip that fails to heat during the lifetime of the plating will be replaced at
no charge. For replacement contact your local retail supplier. Because tip plating is mainly
dependent upon the user's application and practices, tips are not warranted for plating wear.
Heater-tips are warranted against any defects in materials or workmanship. Misused, abused,
altered or damaged tips are not warranted. All heater-tips that fail to heat will be repaired or
replaced at OK International's option. For returns follow the steps outlined below.
RETURN PROCEDURE
Please contact your local OK International Representative for return procedures and policies.
6
www.okinternational.com PS-800 Rev. 3/1/2006
10.

SAFETY INFORMATION

!
WARNING
With power applied, the tip temperature can be > 300°C. Failure to observe the following
precautions may lead to injury to users or damage the equipment:
• Do not touch any metallic parts of the hand-piece
• Do not use near flammable items
• Do not use unit for any function other than described in this manual
• Use only genuine PS replacement parts
• Use in a well ventilated area
• Do not use the equipment with wet hands
• Connect only to properly grounded outlets to prevent risk of electric shock.
• Always place hand-piece back into the workstand to prevent accidental
burning of oneself or surrounding objects.
Although the systems offer superior EOS (Electrical Overstress) protection, periodic checks of the
instrument cord should be incorporated into standard operator maintenance procedures.
Waste Electrical and Electronic Equipment Directive - WEEE (2002/96/EC).
When this product is no longer required, if it cannot be re-used,
we ask our customers not to dispose of it as unsorted municipal
waste but to appropriately recycle the product. In Europe, please
contact your OK International distributor who can advise the
recycling options available (www.okinternational.com).
www.okinternational.com
7
PS-800 Rev. 3/1/2006