Device Functions
- Rear side/inside -
Mixing amplifier-settings
Mixing Amplifier printed circuit board inside
Phantom Power for MIC1 and MIC2
The MX-AMP 60 and MX-AMP 120 allow for operating
Phantom powered condenser microphones.
To add Phantom Power to the MIC1 and MIC2 inputs,
you have to move jumpers on the lower main printed
circuit board.
MIC1
MIC1 (see drawing SW 401)
- Jumper set "on" - position means
- Jumper set "off" - postion means
MIC2
MIC2 (see drawing SW 402)
- Jumper set "on" - position means
- Jumper set "off" - position means
EN
18
Phantom
Power ON
Phantom
Power OFF
Phantom
Power ON
Phantom
Power OFF
ic audio
MUSIC / SPEECH