BOMANN DU 774 G Bedienungsanleitung, Garantie Seite 19

• Drill totally 7x mounting holes for the mounting
brackets and two more holes for the hood body
with approx. 8 mm diameter in the wall. Insert the
dowels [08].
Fasten the bracket hook [07] for the hood body
•
with three screws ST4x30mm [10].
Attach the brackets [05] and [06] at the pre-
•
marked positions with two screws ST4x30mm
[10].
• Before inserting the hood, affix the non-return
valves from the top of the extraction duct by
slightly bending.
For exhaust mode: For exhaust mode: For exhaust mode: For exhaust mode:
• Hereupon a flexible exhaust hose (not supplied)
with an inner diameter of 150 mm must be at-
tached.
• Hang up the hood body onto the wall bracket
hook [07]. Check the safe, horizontal support and
tighten two screws ST4x30mm [10] through the
hood body.
Fo For exhaust mode: r exhaust mode:
Fo Fo r exhaust mode: r exhaust mode:
• Check the correct position of the exhaust hose
and connect it with the outlet opening.
• Put the shaft unit on and secure the lower shaft
with the bracket [05].
• Pull up the inner shaft and fix the shaft cover
sideways with the bracket [06] by screwing in the
screws ST3x10mm [11].
19