Cisco 350 Serie Schnellstartanleitung Seite 10

If this is the first time that you have logged on with the default
username and password, the following message appears:
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [Y]?
Enter Y, and set a new administrator password.
S 5
TEP
Password complexity is enabled by default. The password
N
OTE
must comply with the default complexity rules.
Make sure that any configuration changes made are saved
C
AUTION
before exiting.
You are now ready to configure the switch. Refer to
350switches to locate the CLI Guide for your switch.
If you are not using DHCP on your network, set the IP address type
N
OTE
on the switch to Static and change the static IP address and subnet mask
to match your network topology. Failure to do so may result in multiple
switches using the same factory default IP address of 192.168.1.254.
Cisco 350 Series Switch Features
5
This section describes the exterior of the switch to help familiarize you
with your switch.
Product Models
Model
SF350-48
SF350-48P
SF350-48MP
SG350-8PD
SG350-28
SG350-28P
SG350-28MP
SG350-10
SG350-10P
10
Description
48-Port 10/100 Managed Switch
48-Port 10/100 PoE Managed Switch
48-Port 10/100 PoE Managed Switch
8-Port 2.5 Gigabit PoE Managed Switch
28-Port Gigabit Managed Switch
28-Port Gigabit PoE Managed Switch
28-Port Gigabit PoE Managed Switch
10-Port Gigabit Managed Switch
10-Port Gigabit PoE Managed Switch
www.cisco.com/go/
Cisco 350 Series Managed Switches