D+H VCD 204-K Originalbetriebsanleitung Seite 7

Stroke limiting with magnets
1
Close drive.
99.831.10 1.0/08/13
2
Voltage must continue to
be applied to the drive when
moving in the "CLOSE"
direction. Hold the magnet next
to the drive as shown in the
diagramme (2 sec.) until you hear
a pulsating ton > The drive is now
in learning mode The magnet can
now be removed and the drive no
longer has to be under voltage
appr. 2 sec.
learning mode
English
3
Allow the drive to run
"OPEN" until you reach the
required stroke.
If the stroke is set incorrectly,
the procedure is accidentally
interrupted or the drive
continues to the full stroke
length, please return to point 1
and start again.
STOP
VCD 204 -K
7/16