Checking The Seal - Kemapack OR-T200 Betriebsanleitung

Betriebsanleitung
2
Fig. 10 Welding straps
Fig. 11 Removing tool
2
Fig. 12 Checking of seal
12.08/WE
1
1
3
Service-Hotline: +49 / 8191 / 9177-44
Ersatzteilportal: www.kemapack.com/service/ersatzteile
– Depress button (10/1) completely to the stop. The
straps are welded together and the upper strap is
cut off. The LED indicator (10/2) indicates the cooling
time of the sealing:
LED fl ashing
After fi nishing the friction wel-
ding, the green LED fl ashes for
approx. two seconds.
Do not remove the tool during
~2 sec.
this time!
Continuous LED and audible
signal
+
The sealing cycle is fi nished.
If the straps have not been welded and an
audible signal sounds, this means the tension
button was not depressed.
– After the LED has stopped fl ashing and the audible
signal sounds, raise the rocker lever up to the
handle.
– Swing the tool away from the strapping backwards
and to the right.
– Check the seal (refer to chapter 6.2).
If the tool is used in a dirty environment, it is
recommended that it should be cleaned daily.
In particular the tension wheel and the tooth plate
should be checked for damage and kept clean. This is
best performed by blasting with compressed air (wear
goggles).

6.2 CHECKING THE SEAL

– Check appearance of seal (see fi g. 12) regularly.
If the straps are poorly welded, check the welding
time setting (refer to chapter 6.3.3).
1 Good seal (the complete surface is cleanly welded
without excess material being forced out sideways).
2 Poorly welded seal (not welded over the complete
surface), welding time too short.
3 Poorly welded seal (excess material is forced out
sideways), welding time too long.
An incorrectly welded strapping cannot
secure the package and can thus lead to
injuries.
Never transport or move packaged
goods with incorrectly welded seals.
OR-T200
ORGAPACK OR-T 200
21
21