Operating Instructions; Operating The Tool - Kemapack OR-T200 Betriebsanleitung

OR-T200
ORGAPACK OR-T 200
6

6.1 OPERATING THE TOOL

– Insert charged battery (7/1) into strapping tool.
– Place strap round goods to be packaged, so that
the straps lie one above the other on top of
package. The beginning of the strap is underneath.
Hold the straps with the left hand so that the strap
beginning is approximately 20 cm (8") ahead of the
hand.
– Take the tool in the right hand and lift the rocker
lever (8/1) towards the handle.
– Slide the straps, one on top of the other, into the
tool up to the stop.
The strap lead is now approximately 5 cm
(2") beyond the tool.
– Release the rocker lever.
– Press the push button (9/1). The strap is tensioned
until the required or pre-selected strap tension is
reached.
– The strap tension can be adjusted on the oper-
ating panel (see Chapter 6.3.2).
– The strap can be re-tensioned at any time.
Releasing strap tension
In order to release the strap tension after the tension-
ing process, lift rocker lever (8/1) against handle.
Tensioning – welding:
The welding may also be started before the
strap has been tensioned. However, the tensioning
button must be pressed once before welding.
20
20

OPERATING INSTRUCTIONS

Service-Hotline: +49 / 8191 / 9177-44
Ersatzteilportal: www.kemapack.com/service/ersatzteile
Fig. 7 Place strap around package
Fig. 8 Slide straps into tool
1
Fig. 9 Strap tensioning
Betriebsanleitung
1
1
12.08/WE