Whirlpool AWZ9CD/PRO Sicherheitshinweise, Gebrauchs- Und Installationsanleitung Seite 116

Set dryness level, if needed
If you want to change the dryness level, make
sure that the Dryness level button « lights up .
Turn the knob to select the desired dryness
level, afterwards press the knob to confirm .
Select options, if needed
If you want to select additional options,
make sure that the Options button « lights
up . The options which are selectable for your
programme are indicated by a lighting arrow .
Turn the knob to select the desired options .
The symbol of the selected option blinks . To
confirm it, press the knob .
Some options / functions can be selected by
directly pressing the button .
Refer to section OPTIONS, FUNCTIONS
AND INDICATORS for more information .
CUSTOM MODE
After you have switched on the dryer, you are
not forced to follow the GUIDED MODE .
It is up to you which order you choose to
set your programme . To choose a setting,
first press the relevant button, then turn the
knob to select, and finally press the knob to
confirm .
The variety of options and dryness levels
depends on the programme selected .
Therefore it is recommended to start set-up
by programme selection .
5.
START PROGRAMME
Press and hold Start/Pause « until the button
lights up solidly; the programme starts .
The duration can be recalculated and
adapted in the course of the programme .
During such phases, an animation appears on
the display .
6.
CHANGE THE SETTINGS OF A
RUNNING PROGRAMME, IF NEEDED
You can still change some settings after a
programme has started:
116
• Adjust drying time (only if programme
Drying time or Airing is selected)
• Adjust or cancel Start delay, if a delay option
is already in progress .
• Add or cancel an option, provided the
progress of the programme still allows it .
Press the relevant button . The selected
setting blinks for a few seconds .
While blinking, you can adjust the setting
by turning the knob . If the value or setting
stopped blinking, press the button again .
Press the knob to confirm the modification .
If you do not confirm, the modification is
confirmed automatically — the modified
setting stops blinking .
The programme continues automatically .
To change the settings of a running
programme or delay, you can also:
• press Start/Pause to put the running
programme on hold
• change your settings
• press Start/Pause again to continue the
programme .
7.
CANCEL A RUNNING PROGRAMME, IF
NEEDED
Press and hold the On/Off button « until "rES"
appears on the display .
WARNING
After cancelling a running programme,
quickly remove all items and spread
them out so that the heat is dissipated.
8.
SWITCH OFF THE DRYER AFTER
PROGRAMME END
At the end of the programme, "End" appears
on the display . Press On/Off button « to switch
off the dryer . Open the door and take out
your laundry .
The dryer switches off automatically in about
a quarter of an hour after programme end, to
save energy .