Interval Ventilation; Lighting; Cleaning And Maintenance; Cleaning Agents - NEFF D39G69S0 Gebrauchsanleitung

Interval ventilation

With intermittent ventilation, the ventilation switches on
automatically for 10 minutes every hour. After 24 hours, the
appliance switches off.
Press the 8 button.
1.
is shown on the display.
©¨
Press the 8 button.
2.
The intermittent ventilation switches off.

Lighting

The lighting can be switched on and off independently of the
ventilation.
Press the button.
6
Setting the brightness
Press and hold the button for two seconds.
6
1.
The brightness is reduced.
Press the button.
6
2.
The maximum brightness is restored.

Cleaning and maintenance

:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use any of the following:
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.

Saturation display

When the metal grease filter or activated carbon filter is
saturated, the corresponding symbol flashes:
ª
Metal grease filter:
■
Activated carbon filter:
■
If you have not yet done so, clean the metal grease filter or
replace the activated carbon filter immediately.
For instructions on how to clean the metal grease filter, please
refer to the section "Cleaning and maintenance".
Resetting the saturation indicators
Switch off the motor.
1.
Press and hold the button for two seconds.
7
2.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display must be
switched over accordingly:
Check that the extractor hood is connected and switched off.
1.
Press and hold the "+" button for two seconds.
2.
' flashes twice, i.e. the electronic control is switched over to
circulating-air mode.
Press the "+" button.
3.
flashes once, i.e. the electronic control is switched back to
'
exhaust-air mode.
Area Cleaning agent
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry
with a soft cloth.
Clean stainless steel surfaces in the
grind direction only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.
Apply a very thin layer of the cleaning
product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plas- Glass cleaner:
tic Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Controls Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth/towel.
Risk of electric shock caused by pene-
trating moisture.
Risk of damage to the electronics from
penetrating moisture. Never clean
operating controls with a wet cloth.
Do not use any stainless steel cleaners.
'
15