Olsberg OEC Anleitung Seite 27

● Tighten the motor retaining clip (6) with the spac-
er sleeve in the wood storage compartment. Push
the servo-motor (5) onto the rotation axis of the air
regulator lever and snap into the motor retaining clip
(Fig.11).
● Install the door contact switch (fastening position,
see Fig.11) as described in chapter "General instal-
lation steps", step 2+3.
Fig.11
5
5 ...Servo-motor
6 ...Motor retaining clip
11 ...Door contact switch fastening position
12 ...Temperature sensor fastening position
6 11
● Install the temperature sensor (fastening position on
the back side of the unit, see Fig.12) as described in
chapter "General installation steps", step 4+5.
● Refit the back panel firmly at the top and the bottom
of the unit using the fastening screws (A+C).
● The remainder of the installation is performed as de-
scribed in chapter "General installation steps", step
6-10.
Fig.12
12
27