Switching Audio Sources - Sentiotec wave.com4 sound WC4-BT-D Montage- Und Gebrauchsanweisung

Instructions for use

5.8. Switching audio sources

Switch to a new (not previously paired) audio source
If you want to connect the Bluetooth module with a new audio source, proceed
as follows:
1. Disconnect the Bluetooth connection between the previous audio source and
the Bluetooth module. Observe the information in the operating instructions
for your device.
2. Press the Play/Pause button 3 and the Forward button 2.
► Control LED 1 on the Bluetooth module begins to fl ash quickly and
steadily (pairing mode).
► The Bluetooth module can now establish a connection to a different audio
source for the fi rst time (pairing – see point 5.2 on page 10).
Switching to an audio source that was previously paired
The Bluetooth module stores the pairing information of up to eight audio sources.
To connect the Bluetooth module with previously paired devices, you need to
perform the following steps:
1. Disconnect the Bluetooth connection between the previous audio source and
the Bluetooth module. Observe the information in the operating instructions
for your device.
2. Manually establish a Bluetooth connection between the new audio source
and Bluetooth module:
● Choose "wave.com sound" from the list of paired devices.
WORLD OF WELLNESS
p. 13/18
EN