Troubleshooting - SOLIS 703.01 Bedienungsanleitung

▲
S T O R A G E
• Check if the appliance is switched off and the power plug is pulled resp. the
power cord is removed. The water has to be drained completely.
• Check if the appliance inside is completely clean and dry. If necessary, let the
appliance stand open until the humidification plates and the water basin are dry
on the inside.
• Keep the appliance standing upright in a dry, dark spot, best in the original pack-
aging. Do not place anything on the appliance.
• Always keep the appliance and power cord out of the reach of children.
86
▲
T R O U B L E S H O O T I N G
Problem Possible cause
Little – The function " LOW " was
humidification selected, using the
power. " speed " button.
– The water in the water
basin is very cold.
No – The power plug is not
humidification connected to the power
power. outlet or the connection
adapter is not correctly
plugged into the appli-
ance jack.
– The warning light
" WATER SHORTAGE " has
illuminated, then the
appliance and all displays
have turned off.
An indepen- – Dirt has collected in the
dent humidity air outlet or inlet opening.
switch mea-
sures a differ-
ent humidity
value from the
display on the
appliance.
– The appliance is placed
near a window or an
open door.
The escaping – There is old water in the
air smells water basin.
unpleasantly.
– Old water was left over in
the water basin and
merely mixed with new
water.
Solution
– Select a higher humidification
power, f.e. " MID " or " HIGH " .
– Select the humidification power
" HIGH " with the " speed " button.
After 10 minutes, humidification
power will have increased.
– Firmly connect the power plug to
the socket and the connection
adapter to the appliance jack.
– Fill the water basin up to the MAX
marking with fresh tap water, then
reinstall the appliance top.
– Clean the air inlet and outlet
openings. NOTE: Even within one
room, different values for humidity
can be measured. The " CURRENT
HUMIDITY " value only refers to
the humidity directly by the appli-
ance.
– Place the appliance in a spot free
of draft.
– Drain the water and clean the
appliance as described in
" Cleaning and maintenance " .
Fill the water basin with fresh tap
water.
87