Cleaning And Maintenance - SOLIS 703.01 Bedienungsanleitung

▲
C L E A N I N G A N D M A I N T E N A N C E
• The recommended cleaning intervals are dependent on air and water quality as
well as operation time and frequency.
• Before cleaning, always switch the appliance off and pull the power plug from
the socket resp. the power cord from the appliance by pulling the connection
adapter from the appliance jack.
• We recommend refilling fresh water on a daily basis.
W E E K LY C L E A N I N G O F T H E W AT E R B A S I N A N D
H U M I D I F I C AT I O N P L AT E S
• Dirt particles and microorganisms collect in the water basin during use, which
is why the basin has to be cleaned regularly, at least once a week. Use tap water
(max. 30°C warm!) with a small amount of mild detergent and a soft cloth resp.
a soft sponge. After that, thoroughly rinse the basin inside with water. Dry the
basin inside with a soft cloth and let it air-dry while the appliance is open.
• Approx. every 4 weeks, the humidification plates should be cleaned. Remove
the humidification plates from the water basin and loosen the plastic screw on
the front side of the axle. The humidification plates can now be removed from
the axle one by one. Clean the humidification plates with a cloth resp. soft
sponge and warm (max. 30°C) tap water containing some mild detergent.
Then, replace the humidification plates on the axle and finally replace the plas-
tic screw before reinserting the humidification plates in the water basin.
• It is vital that the 3 in 1 Airwasher Ionic is completely drained and cleaned if the
water-filled appliance has been out of use for more than one week.
• CAUTION: The humidification plates and the water basin can not be cleaned in
the dishwasher!
• In general, do not use any aggressive or abrasive detergents or metal sponges,
as these might damage the surface.
84
D E C A L C I F Y I N G T H E W AT E R B A S I N A N D
T H E H U M I D I F I C AT I O N P L AT E S
• If the water basin and the humidification plates are calcified, both should be
cleaned with SOLIPOL ® forte. Depending on water hardness, this should be done
at least once a month, if the water is very hard even once every two weeks.
• Pour 3 liters of water (approx. 30°C warm) into the water basin and add 1 liter
SOLIPOL forte. Reassemble the appliance and let it run for at least one hour in
®
a well ventilated spot (ideally outside, f.e. on the balcony). We recommend only
using SOLIPOL forte for decalcifying. The remedy of defects caused by improper
®
decalcifying agents is excluded from warranty.
• Depending on the limescale deposits it may take longer for all limescale deposits
to be removed.
• Afterwards, carefully rinse water basin and humidification plates with water and
dry them.
C L E A N I N G T H E A P P L I A N C E T O P A N D
T H E W AT E R B A S I N O U T S I D E
• Clean the appliance top and the outside of the water basin regularly with a
slightly wet cloth and a mild detergent.
• In general, do not use any aggressive or abrasive detergents or metal sponges,
as these might damage the surface.
85